We may earn a commission from links on this page. Learn more about affiliate links

Trane E3.2: Open pressure switch, 1st stage: PS1 is open when it should be closed

Ref. TRANE-E3-2 · From the Trane furnace manual · Updated 2026-10-23

Status codeE3.2Trane
What it means

Open pressure switch, 1st stage: PS1 is open when it should be closed.

Call a profurnace
How it shows: 7-segment display alternates with mode: E3.2

Find a local HVAC pro →

§1Likely causes

  • Obstructed pressure switch hose or flue piping, or incorrect vent size
  • Wind gusts
  • Inducer motor not running
  • PS1 not oriented correctly
  • Faulty pressure switch

§2Safe DIY steps

  1. Check outdoor vent and intake terminations for blockage
  2. Techniciancheck PS hose, flue piping and vent size
  3. Techniciancheck inducer voltage and operation; replace inducer assembly or pressure switch as indicated
Safety firstIf you smell gas, do not touch any electrical switch or use a phone in the building; leave immediately and call your gas supplier from outside. Turn off electrical power at the furnace switch or breaker before opening any panel, and never bypass or jumper a limit, rollout or pressure switch. Gas valve, burner, venting, wiring and control-board work should be done by a licensed HVAC technician.

§3When to call a pro

Call a licensed HVAC technician: if terminations are clear and the code persists.

Find a local HVAC pro →

§4Other Trane codes

E01Trane

Loss of the IRQ or other internal failures (internal furnace control error).

E04Trane

Open limit: main thermal limit, flame rollout switch, or reverse airflow switch.

E05Trane

Flame detected when it should not be present.

E06Trane

Voltage reversed polarity or bad grounding.

E08Trane

Low flame current, but still strong enough to allow operation.

E09Trane

Open inducer limit switch or condensate pressure switch.