We may earn a commission from links on this page. Learn more about affiliate links

Rheem 57: High pressure switch open with inducer on high speed; furnace may drop to low fire

Ref. RHEEM-57 · From the Rheem furnace manual · Updated 2026-10-23

Status code57Rheem
What it means

High pressure switch open with inducer on high speed; furnace may drop to low fire.

Call a profurnace
How it shows: Dual 7-segment display: 57

Find a local HVAC pro →

§1Likely causes

  • Blocked or improperly terminated vents
  • Vent length or elbows exceed maximum
  • Faulty or disconnected inducer
  • Faulty control board
  • High altitude kit not installed
  • Loose or faulty wiring
  • Damaged pressure switch hoses
  • Wind gusts
  • Faulty pressure switch

§2Safe DIY steps

  1. Check outdoor vent terminations for blockage
  2. Techniciancheck venting, inducer, hoses and pressure switch
Safety firstIf you smell gas, do not touch any electrical switch or use a phone in the building; leave immediately and call your gas supplier from outside. Turn off electrical power at the furnace switch or breaker before opening any panel, and never bypass or jumper a limit, rollout or pressure switch. Gas valve, burner, venting, wiring and control-board work should be done by a licensed HVAC technician.

§3When to call a pro

Call a licensed HVAC technician: if vents are clear and the code persists.

Find a local HVAC pro →

§4Other Rheem codes

10Rheem

One-hour lockout, caused by repeated failed ignition (11), water sensed (59), dead blower (61), internal fault (93), flame lost 5 times (13) or unexpected flame (14).

11Rheem

Failed ignition. After four failed attempts the control enters one-hour lockout (10).

12Rheem

Low flame sense: flame sense current is weak or marginal. Furnace keeps running.

13Rheem

Flame lost after established.

14Rheem

Flame present with gas valve off. Extremely critical; furnace will not operate.

30Rheem

Open fuse, usually from a 24 VAC short to common or ground.